Pioneer DDJ-SR Service Manual page 21

5
(*4) Cross fader
MIN MAX
In Crossfader, the position is indicated in 9 steps from minimum to maximum.
1 2
MIN
(*5) CROSS FADER REVERSE switch
(*6) Press the Rotary selector
Mode: LED BRIGHTNESS Mode
Mode All LED
A FULL BRIGHTNESS: 100 %
B MID BRIGHTNESS: 20 %
C LOW BRIGHTNESS: 10 %
D OFF
When Rotary selector is pressed,"LED BRIGHTNESS Mode" is changed cyclically as follows.
• • • → A → B → C → D → A → • • •
When Rotary selector is pressed, "LIGHTING COLOR Mode" does not change.
(*7) Rotate the Rotary selector
Mode: LIGHTING COLOR Mode
(Each mode is indicated with the combination of lighting colors of the LOAD button and the HOT CUE, ROLL, SLICER,
and SAMPLER buttons.)
Mode
LOAD
1 RED & AMBER
2 AMBER
3 AMBER
4 RED
5 RED
When Rotary selector is rotated clockwise,"LIGHTING COLOR Mode" is changed cyclically as follows.
• • • → 1 → 2 → 3 → 4 → 5 → 1 →• • •
When Rotary selector is rotated counterclockwise,"LIGHTING COLOR Mode" is changed cyclically as follows.
• • • → 5 → 4 → 3 → 2 → 1 → 5 →• • •
When Rotary selectoris rotated, "LED BRIGHTNESS Mode" does not change.
*As two LEDs of different colors each are embedded in the LOAD button and the HOT CUE, ROLL, SLICER, and
SAMPLER buttons, LIGHTING COLOR mode can be used for failure diagnosis of each LED.
5
6
3 5
• • •
OFF
LIGHTING COLOR of LED
HOT CUE, ROLL,
SLICER, SAMPLER
BLUE & RED
BLUE
RED
BLUE
RED
DDJ-SR
6
7
6
• • •
ON
Other LEDs
State of (*6) retained
7
8
A
8 9
MAX
B
C
D
E
F
21
8