Table of Contents
Advertisement
Self-regulating trace heating systems
End termination
21-1S00-7D0001/-
05/2023-EHT-466853
Design Guide for Hazardous / Industrial
ELL-200 End of line lamp
End of line lamp for connection of a trace
heater. Includes a mounting stand for on-pipe
installation. The kit is approved for Zone 1
and Zone 2 areas.
2 pipe straps per stand required.
For a complete list of kit contents and approvals see
data sheet.
ELL-300 End of line lamp
End of line lamp for connection of a trace
heater. Includes a mounting stand for off-pipe
installation. The kit is approved for Zone 1
and Zone 2 areas.
2 pipe straps per stand required.
For a complete list of kit contents and approvals see
data sheet.
CAK-E5/E10 Cold applied end seal
Silicone end seal for insulation of the end of
the trace heater. Suitable to all Bartec paral-
lel trace heating cable. Approved accordingly
IECEx, ATEX, CSA (ordinary and hazardous
locations)
CAK-E5
5 pcs.
CAK-E10
10 pcs.
ELS-200 high profile end seal
End seal for access above the insulation.
2 pipe straps per mounting stand required.
For a complete list of kit contents and approvals see
data sheet.
Plexo TCS end seal
Plug-in end seal for easy connection of trace
heaters
Notice Technical data subject to change without notice.
No claims for damage arising from alternations, errors or misprints shall be allowed.
Catalog No.: ELL-200-E
Part No.: 27-54E2-4212/F210
Option top light available on request.
Catalog No.: ELL-300-E
Part No.: 27-54E2-4211/F210
CAK-E5:
Catalog No.: CAK-E5
Part No.: 27-59CZ-90000005
CAK-E10:
Catalog No.: CAK-E10
Part No.: 27-59CZ-90000010
Catalog No.: ELS-200
Part No.: 27-54E2-AA12A000
Catalog No.: PLEXO-TCS
Part No.: 27-59P3-0010
Page 28 / 42
Advertisement
Table of Contents
