Table of Contents
Advertisement
GENERAL TIPS
• Before opening the Arm-Evac, always turn off the power source. • Protect the Arm-Evac and
accessories from dampness. • Do not extract water vapor or steam. • The Arm-Evac must not be
used without filters. Impurities in the extracted air can damage the motor pump. • Do not allow the
Arm-Evac or ducting hoses to become blocked. • Do not extract corrosive compounds without
checking with PACE. • Recalibrate the Arm-Evac 250 whenever a filter change or system
configuration change occurs.
FILTER REPLACEMENT
Pre-Filter
This filter removes coarse particles from the air. In general, the pre-filter must be changed on a
monthly basis. However, depending on your particular process, the filter may need to be changed
more or less frequently. A visual inspection on a weekly basis is recommended.
Main Filters
Fume extraction filters remove particulates from the air and capture noxious odors and gases.
Depending on your particular process, the filter cartridge may need to be changed more or less
frequently.
Replacement Procedure
1) Turn Power Switch to the Off ("O") position.
2) Remove the Filter access cover.
3) Remove the old Filter cartridge (or cartridges).
4) Install a new Filter (or filters). On the Arm-Evac 250, insure that the Pressure Tube (black•coiled
cable inside filter compartment) does not become kinked when the new Filter is installed.
Important
BE SURE the new filter cartridge is installed with the airflow
arrow pointing downward and Pressure Tube does not
become kinked.
5) Replace the Filter access cover.
6) Dispose of used Filters properly.
7) Arm-Evac 250 Systems Only: Recalibrate according to Self-Calibration Procedure (see Page 9).
8) Turn Power Switch to the On ("1") position.
Orion Industry – 16 chemin de la Guy – 91160 Ballainvilliers – France - Tel +33 1 69 34 53 11
E mailto:info@orion-industry.com- W
http://www.orion-industry.com/
ARM-EVAC® 250 & 200 SYSTEMS
MAINTENANCE
Page 16 sur 18
Advertisement
Table of Contents
