Table of Contents
Advertisement
ARM-EVAC® 250 & 200 SYSTEMS
OPERATION
Setup/Operation
Use the following procedure to set up and operate the Remote Control. Refer to illustration
below. 1) Attach the end of the Benchtop Controller Cable identified as "250" to the connector
located on the back of the Arm-Evac 250 identified as "Remote". Refer to illustration below. 2)
Attach the end of the Benchtop Controller Cable identified as "REM" to the connector located
on the Benchtop Controller (item C)). 3) Position the Benchtop Controller in convenient
location. 4) Once the cables are connected, assume normal operating procedures.
NOTES
Once connected to the Arm-Evac 250, the Benchtop Controller will over-ride all controls with
the exception of the keyed calibration switch and Green lighted Power Switch. If the self-
calibration procedure is initiated while the Benchtop Controller is connected, the LED Display
on the Benchtop Controller will mimic the filter condition gauge (refer to item 0) as identified
in the "Arm-Evac 250 Self-Calibration Procedure".
Arm-Evac 250 RS232C Output for ISO 14000 Software
The Arm-Evac 250 has a microprocessor integral with its electronic control circuitry which can
transfer data to support ISO 14000 documentation requirements. The output connector
(marked "PC COMS ") on the back of the Arm-Evac 250 and cable connection provides a
communication link for transfer and storage of data to a computer.
Contact your local PACE representative or contact PACE directly to obtain detailed operating
instructions.
Orion Industry – 16 chemin de la Guy – 91160 Ballainvilliers – France - Tel +33 1 69 34 53 11
Page 15 sur 18
E mailto:info@orion-industry.com- W
http://www.orion-industry.com/
Advertisement
Table of Contents
