Siruba C007K Instruction Book page 31

'
'
'
'
'
'
'
I - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - I - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
r ~t~tUiU~2~~
.............
ADJ~STI~GNf:EDLET~READTA~E-UP
..
f--- ------- ------------- ------------- ------------- ------------- -----
1-~~~~~ti~ID~~~IDm~~ti~
~~•ftm~~~@~m*~,@~~
1.&~8**®~~2.
0
(
Ill 25)
2.
~~B**®~OO '~~
A '
B
~~~~~~
-~
75
mm
:jij~W ~
o
1. When turning the pulley and make the
needle bar in the lowest position, the top
edge of the needle thread take-up
ro
should remain horizontal. To adjust the
position of the take-up if necessary,
loosen the screw@ . (Fig.25)
~25/Fig.25
2. Loosen screw® to adjust the length
between point A and B to be about 75 mm,
then fasten it tightly.
Note:
To loosen the needle thread, turn the
needle thread take up@ toward the
left. To tighten the needle thread, turn
the needle thread take up@ toward
the right.
3. Do not move the spreader thread take-up
@when making above adjustments.
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
r - -------------------------- --
-- ------ - ----------- ----------------------------------------
- ----------- ------- - ------- ------------- ---
: _ _ _
~_ : =_ ~ ~-~:~~!~- ~ - ~ - ~ -- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ~ ~~~~~T~- ~ - ~ - ~ ~- ~ - = ~- ~ - = - ~ - - ~ - ~ - ~ =~~- - - - - - - - - - - - - - -
1.
~~Jl.!~~**~~m•~~~!!~B~
,
~-~:&
**~~®~~'J'~
A
~~~llW~:&**~~ffi~2.
~~@;[OJ~
0
(
Ill 26)
2.@~~~~~~~00BM@&@,~~
ti~~Jl.~~~~~®, ~~~~W~2.
o
-26-
1. When the spreader thread take-up ffi is
adjusted to the top, the small hole A of the
other spreader thread take-up must be at
the same level with the long groove of the
Spreader Thread Take-up ffi . (Fig.26)
2. For necessary adjustment, loosen screw
@and@ first, move the Spreader Take-
up® up and down, and then fasten the
screws again.