Recon HUMMER EV Owner's Manual page 8

3. Plug the light into the matching red receptacle in the wire bundle. (NOTE: Be careful not to bend the wire
prongs inside of the plugs.)
6.) Rear fender & rack installation (optional):
1. Attach the rear racking using (4) long bolts, (8) washers, and (4) nuts. Align the rack with the (4) rack brackets
on the frame. Insert the bolt and washer into each of the holes and thread the washer and nut on the other
side. Hand tighten. It is best to keep these loose until all (4) rack bolts and (2) fender bolts have been installed.
2. Attach the rear fender to the frame (hole is located on the bracket between the top (2) rack brackets) using the
(2) smaller bolts. The thinner bolt and wide washer will be used to secure the fender to the frame. The
remaining small bolt, (2) washers, and (1) nut will be used to install the fender to the rear rack. (See photos
below.)
3. Once all rack bolts and fender bolts are installed, tighten them down evenly (adjusting the alignment of the rack
and fender as needed).
7.) Brake pad & rotor adjustment (if applicable):
If there is audible rubbing between the brake pads and the brake rotor, it may be necessary to adjust the front and rear
brake housing after installation and repeated use.
1. Loosen the top and bottom bolts of the brake housing. DO NOT completely remove the bolts. Once loose,
center the brake rotor between the brake pads. Tighten the top and bottom housing bolt being careful not to
move the brake housing. Spin the tire to listen for rubbing. Make small adjustments to the housing, as needed,
to eliminate rubbing.
8