Section 1: Assembly Instructions - Recon HUMMER EV Owner's Manual

SECTION 1: ASSEMBLY
WARNING:
Incorrect assembly, maintenance, or use of your HUMMER EV AWD E-Bike can cause component
or performance failure, loss of control, serious injury, or death. All operators of this E-Bike must read and understand
the entire manual before riding. If you are not sure you have the experience, skills, and tools to correctly perform all
assembly steps in the manual, consult a certified, reputable bike mechanic.
1.) Unboxing:
Required Tools:
Cutting pliers or utility knife (to cut box strapping and heavy bike banding) – not included
•
Scissors (to remove bubble wrap and protective packaging materials) – not included
•
• 8mm, 10mm, 15mm, and 19mm wrenches – included
• 3mm, 4mm, 5mm, and 6mm Allen wrenches – included
• 2.5mm Allen wrench – not included
1. Cut and remove banding straps from exterior of box.
2. Locate and remove Tool Kit and Accessories Box containing the pedals, battery charger, hardware, front light,
and tools.
3. Remove bike and remaining parts from the box. (NOTE: Lay box on side and slide bike out or use two people to
lift it out.)
4. Cut the packaging straps to remove the front tire from the frame of the bike. (NOTE: Use caution when cutting
the straps making sure to avoid brake lines and cables.)
5. Cut packaging straps to remove the fenders from the tires.
6. Cut packaging straps to release the handlebars from the bike frame. (NOTE: Check to make sure the cable
connections did not pull apart or disconnect during this step or in shipping.)
7. Remove remaining bubble wrap, foam, and other shipping materials from the bike.
2.) Handlebar installation:
1. For shipping reasons, the handlebar stem is shipped facing in the reverse direction. Spin the stem to the correct,
forward-facing position. (NOTE: The stem bolts will still be loose. These will be tightened after the front tire is
installed to ensure proper alignment.)
2. Using the 4mm Allen wrench, remove the (4) bolts from the bicycle stem. Remove the front plate of the stem
and then insert the handlebars into the stem. Center the handlebars making sure that the thumb throttle is on
the left side of the bike. Reattach the front plate and secure using the (4) bolts. Prior to tightening, adjust the
angle of the handlebars that is preferred for the operator. Completely tighten the (4) bolts. In most cases, the
brake levers should be angled approximately 45 degrees downward.
3. The display screen can easily be rotated by hand for proper alignment with the operator's field of view. To
tighten (if desired), use a 2.5mm Allen wrench (not included).
6