Section 2: Battery Installation, Care, And Maintenance - Recon HUMMER EV Owner's Manual

10.) Torque specifications:
Before your first ride, verify that all fasteners, nuts, and bolts are torqued to the proper specifications outlined
below.
WARNING:
torque can result in bike or component
failure, resulting in serious injury, death, or
property damage.
SECTION 2: BATTERY INSTALLATION, CARE, MAINTENANCE
The battery that comes with your HUMMER EV AWD E-Bike is a state-of-the-art, lithium-ion battery produced by LG,
that's designed to give you years of power with proper care and use. Follow the recommendations here for the best
possible performance.
WARNING:
Charging your battery with a charger other than one supplied by RECON Power Bikes and
designed for your specific bike can cause damage to your bike's electrical system or create a fire hazard. Only use a
battery charger designed for your bike and supplied by RECON Power Bikes.
1.) Installing and operating the battery:
1. To install the battery, use the supplied battery key to turn the lock on the bike counterclockwise until it stops
Note:
spinning. (
2. Turn the handlebars completely to the left to make sure the front fender does not interfere with the installation.
3. Locate the bottom of the battery (this is the end with 6 slots for the battery contacts). Carefully insert the
battery with the slotted end down towards the pedals with the protective cover facing the ground.
4. Turn the battery latch, on the bottom of the bike, to the side while inserting the battery. You should hear an
audible click when the battery snaps into position. The latch will also return to its original position.
5. After the battery is installed, turn the key clockwise until it stops to secure the battery into the bike.
6. Keep your key in a safe place. It is used to remove the battery from the bike.
Failure to ensure proper
Do not force the key and lock as it may cause damage.)
Location Component
Handlebars Stem clamp bolts
Stem faceplate bolts
Brake level clamp bolts
Throttle clamp bolt
Display bolts
Brake Area Brake housing to frame
Seat Area Seat adjustment bolt
Seat post height adjustment
Dropout Areas Front axle nut
Rear axle nut
Bottom Bracket Pedals into crank arm
and Crank Area Chainring bolts
Rec. Torque
10 Nm
6 Nm
6 Nm
3 Nm
Securely tighten; do
not overtighten
10-12 Nm
15 Nm
Securely tighten; do
not overtighten
40-45 Nm
40-45 Nm
35 Nm
10 Nm
10