Section 3: Bike Operation, Riding Tips, And Safety - Recon HUMMER EV Owner's Manual

• DO NOT store the battery in temperatures exceeding 104 degrees F. They can be stored in cooler environments
down to 32° F, but must be warmed up to room temperature before charging.
DO NOT charge the battery when freezing! Attempting to charge a frozen battery can cause irreversible damage.
•

SECTION 3: BIKE OPERATION, RIDING TIPS, AND SAFETY

1. How to turn the bike on:
1. After the battery has been charged and has been properly installed
into the bike. Push and hold the POWER (
and "-" buttons on the left side of your handlebar. The display
screen will turn on and light up.
2. Display screen and controls:
1. The display screen will show you:
a. Current Time (top left of screen)
b. Battery Level (top right)
c. Current Speed and Wattage Output (center)
d. Trip Counter (bottom left)
e. Odometer (bottom right)
f. Pedal Assist Level (PAS) (bottom center)
2. To adjust the Pedal Assist Level (PAS), push the "-" button to DECREASE PAS level and push the "+" button to
INCREASE PAS level.
a. RECON always recommends starting in PAS Levels 1 or 2 until the operator is comfortable with the bike
before increasing to higher levels of motor output.
3. RIDING MODES – To adjust between different riding modes, toggle the red
button below the thumb throttle to the left, center, or right positions. The
current mode will be shown on the display by indicating which motors are
active.
a. Left = Traction Mode (Front Wheel Drive)
b. Center = Adrenaline Mode (All Wheel Drive)
c. Right = Cruise Mode (Rear Wheel Drive)
d. Note: Using Adrenaline Mode or the thumb throttle exclusively will
decrease the range.
) button above the "+"
13