Communication Services And Used Port Numbers - Siemens SINUMERIK ONE NCU 1740 Equipment Manual

Interface overview
Table 8-1
Interface
DRIVE-CLiQ
Digital inputs/outputs
24 VDC power supply
PROFINET
Ethernet IE1/OP
Ethernet IE2/NET
PROFIBUS DP1
USB
Ethernet (service socket)
SD Card
Service socket
Note
Interface X140 is only designed for service purposes, and cannot be used to connect a display.
8.2

Communication services and used port numbers

SINUMERIK supports the protocols listed in the following tables. The address parameters, the
relevant communication layer as well as the communication role and the communication
direction are specified for each protocol.
This information allows you to match the security measures for the protection of the automation
system to the used protocols (e.g. firewall).
The following table shows a section of the various layers and protocols that are used.
NCU 1740
Equipment Manual, 09/2022, A5E51087503B AC
Overview of the interfaces that can be used
Designation
X100 - X103
X122, X132, X142
X124
X150; port 1, 2
X160; port 1
X120
X130
X126
X125, X135
X127
X55
X140
8.2 Communication services and used port numbers
Connector type
Spec. RJ45 socket
3x14-pole spring-loaded terminals
Screw-type terminals, 4-pin
Standard RJ45 socket
Standard RJ45 socket, not suitable for
PoE
Standard RJ45 socket, not suitable for
PoE
9-pin SUB-D socket
Double SuperSpeed, type A socket
Standard RJ45 socket, not suitable for
PoE
SD standard slot
DisplayPort socket
Connecting
59