Toro Power Max 1028 Operator's Manual page 6

Figure 7
1. Cable clamp (2)
Important:
Ensure that the curved side of
the cable clamp is against the handle and
that the cable is routed below the clamp bolt.
The cable must be in a straight line from the
cable clamp to the point where it attaches to
the wheel-clutch lever.
4. Pull the cable jacket down gently until the
wheel-clutch lever is down and the slack is out
of the cable, then tighten the cable-clamp nut
securely (Figure 8).
Figure 8
5. Squeeze the lever fully, then check the gap
between the bottom of the handle and the end
of the wheel-clutch lever
Figure 9
Note:
The gap should be approximately the
thickness of a pencil (1/4 inch or 6 mm). If it is
greater, loosen the cable-clamp nut, slide the
cable jacket up slightly, tighten the cable-clamp
nut, and check the gap again.
6. Repeat steps 2 through 5 for the other cable.
g001304
g259955
(Figure 9).
g001306
6