Shutting Off The Engine; Operating The Handwarmers; Operating The Traction Drive - Toro Power Max 1028 Operator's Manual

Shutting Off the Engine

Important:
Wait for all moving parts to stop before leaving the operating position.
Operating the
Handwarmers
Operate the handwarmers as follows:
•
Press the switch to the O
handwarmers.
•
Press the switch to the O
handwarmers.
Figure 22
1. On/Off switch
2. O position
N
position to turn on the
N
position to turn off the
FF
g026460
3. O position
FF
Figure 21
Operating the Traction
Drive
CAUTION
If the traction drive is not properly adjusted,
the machine may move in the direction
opposite of what you intended, causing injury
and/or property damage.
Carefully check the traction drive and adjust
it properly, if necessary; refer to
and Adjusting the Traction Cable (page 22)
more information.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 22)
to an Authorized Service Dealer for service.
1. To engage the traction drive, squeeze the left
(traction) lever to the handgrip
2. To stop the traction drive, release the traction
lever.
15
Checking
Checking and Adjusting
or take the machine
(Figure 23).
Figure 23
g252411
for
g001011