Advertisement
How to use the dishwasher
1. After loading the dishwasher, close the
door properly and open the water
supply tap.
2. Press the On/Off button to switch the
dishwasher on. One of the programme
indicator lamps will switch on.
3. Select the desired programme by
pressing the corresponding button. The
corresponding indicator lamp lights
up. If required, select options (if supplied).
4. Press the Start button to start the
selected programme. The Start
indicator lamp will light up. Once set,
the programmed data cannot be
altered by pressing the programme
selector buttons.
Note: Once the Start button
has been pressed, the dishwasher
memorises the last programme selected.
This information remains in the memory
even during interruption of the power
supply.
To change the selected
programme, press the Start
button for about 5 seconds, until
the Start indicator lamp
switches off. Select a new
programme using the
programme selector knob and
press the Start button.
Note: If the dishwasher is switched off
during a wash programme, when
switched on again the dishwasher
resumes the wash cycle from where it
was interrupted.
Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Danger of scalding from
steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and the End indicator lamp (if fitted)
switches on (for about 30 min.).
6. Once the Start indicator lamp has
switched off, press the On/Off button to
switch the dishwasher off. All the
indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
Upper rack
Rack height adjustment:
(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be changed
when loaded.
Please read the user instructions carefully.
Upper and lower rack
• To lower: pull out the two side
handles and gently lower the rack.
• To raise: pull up the two side handles
until the rack clicks into place.
• The rack must be level on both sides.
Crockery Holders:
• Down:
cups and long-stemmed glasses.
• Up: plates.
"Vario Organizer" multi-purpose
support:
• To be used, for example, for long-
handled utensils (arrange knives
with the blade facing downwards),
cups and glasses.
• May be used in three different
positions (see also "Dishwasher
loading instructions" on Page 4).
1. Upon the left-hand side of the rack.
2. Upside-down, towards the centre of
the rack.
3. Upside-down, towards the left side.
Glass holder:
Lower rack
C
Cutlery basket (C):
• with or without handle (depending
on model).
• The cutlery basket can be removed
to increase available space
C
Advertisement
