Bauknecht GSFL 3131 Quick Reference Manual

Quick reference guide
PROGRAM SELECTION START/RESUME BUTTON
BUTTON Push this button to start the selected program: the
Push "Programs" button indicator lights up and goes off at the end of the
(repeatedly) until the indicator program. When the door is opened during a
of the required program lights washing cycle, the cycle is temporarily paused: the
up (see "Table of programs" Start indicator blinks. To resume the cycle close
below). the door and push Start button again.

Table of programs

P
Programs
1 Sensor 50-65°C
2
Pre-Wash cold
3
Quickwash 45°C
2)
4
50°C
Bio Normal
5
Intensive 70°C
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programs as a result of the appliance's automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
"nk_customer@whirlpool.com".
3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697
standard of November 2001.
(see at right for options description)
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher
(1 minute process).
If the indicator flashes repeatedly, see page 6 -
chapter "What to do if ...".
Deter-
Available gent
Loading instructions
options
Recommended program for
Delay
Antibacterial routine washes, with dried-
rinse on food (e.g. EN 50242).
Crockery to be washed
Delay
later.
Lightly soiled crockery, with
Delay
no dried-on food.
Delay
Normally soiled crockery.
Antibacterial
Energy-saving program.
rinse
Recommended program for
Delay
heavily soiled crockery,
Antibacterial
especially suitable for pans
rinse
and saucepans.
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

Options and display description

SALT INDICATOR
When lit (at the end of the
cycle), the salt reservoir
needs to be refilled.
ANTIBACTERIAL RINSE
This function activates an
Consumption antibacterial rinse at the end
of the wash cycle,
guaranteeing a further
1)
Litres kWh
reduction of bacteria. Press
Minutes
the button to activate or
deactivate the function. This
function can be used with
X 7-14 1.00-1.60 70-155
the programs indicated in
the table of programs. The
dishwasher door must be
kept shut for the entire
— 4.0 0.03 14
duration of the program in
order to guarantee
reduction of bacteria. If the
X 11.0 0.80 30
door is opened the indicator
lamp starts flashing.
X 12.0 1.05 165
TABLET SETTING
This setting allows to optimize the cycle performances
X 14.0 1.55 155
according the type of detergent used.
Push the Tablet button for 3 seconds (until the indicator
lights up) if you are using the combined detergents in
tablet (rinse aid, salt and deteregent in 1 dose).
If you are using powder detergent or liquid detergent,
the Tablet indicator on the control panel has to be off.
GSFL 3131
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
3)
5019 496 01689
Chart
RINSE AID INDICATOR
When lit (at the end of the
cycle), the rinse aid
dispenser needs to be
refilled.
DELAYED START
BUTTON
The wash cycle can be
programmed to start
after 2, 4 or 8 hours.
Then press the Start
button. The wash
program will start after
the set time.
GB -1-