Table of Contents
Advertisement
Care and Maintenance
It is advisable to clean when the appliance is cold and especially for cleaning
the enamelled parts.
Avoid leaving alkaline or acidic substances (lemon juice, vinegar, etc.) on the
surfaces.
Avoid using cleaning products with a chlorine or acidic base.
If a tap becomes stiff, do not force; contact your local After Sales Service Centre.
It is advisable to clean when the appliance is cold and especially when cleaning
the enamelled parts.
Important: The use of suitable protective clothing/gloves is recommended
when handling or cleaning this appliance.
Important: The manufacturer declines all liability for possible damage
caused by the use of unsuitable products to clean the appliance.
WARNING
When correctly installed, your product meets all safety requirements laid
down for this type of product category. However special care should be
taken around the rear or the underneath of the appliance as these areas
are not designed or intended to be touched and may contain sharp or
rough edges, that may cause injury.
Electronic Programmer Display Cleaning
Clean the programmer display using a soft cloth, warm water and neutral soap,
or a soft cloth with a liquid detergent (non-abrasive).
When cleaning, be careful to move the cloth in one direction only.
Then wipe the display with a damp cloth and dry it with a soft cloth.
IMPORTANT: DO NOT use chlorine-based or acid-based cleaning products,
abrasive products or non-neutral detergents as they may cause irreparable
damage to the surface. DO NOT spray cleaning liquids directly on the
programmer display.
Enamelled Parts
All the enamelled parts must be cleaned with a sponge and soapy water only
or other non-abrasive products.
Dry preferably with a micro fibre or soft cloth.
Stainless Steel, Aluminium, Painted Parts and Silk-screen Printed
Surfaces
Clean using an appropriate product. Always dry thoroughly.
Stainless steel surfaces: can be cleaned with an appropriate stainless steel
cleaner.
IMPORTANT: these parts must be cleaned very carefully to avoid scratching
and abrasion. You are advised to use a soft cloth and neutral soap.
34
IMPORTANT:
Before any operation
of cleaning and
maintenance
disconnect the
appliance from the
electrical supply.
Under no circumstan-
ces should any
external covers be
removed for servicing
or maintenance
except by suitable
qualified personnel.
CAUTION:
Do not use abrasive
substances or non-
neutral detergents as
these will irreparably
damage the surface.
CAUTION:
Do not use a steam
cleaner because the
moisture can get into
the appliance thus
make it unsafe.
CAUTION:
Do not store
flammable material
in the oven.
CAUTION:
Do not use harsh
abrasive cleaners or
sharp metal scrapers
to clean the oven
door glass since
they can scratch the
surface, which may
result in shattering of
the glass.
Advertisement
Table of Contents
