Chapter 2 Lan Installation; Wireless Print - SMC Networks EZ Networking SMC2621W-P User Manual

Chapter 2 LAN Installation

3. Connect the Network Cable
Connect the network cable to the 10/100BASE-T LAN connector
on the Wireless Print Server.
Note:
4. Power Up
Plug in the power adapter cable and power up. Start-up will take
only a few seconds.
Use only the Power Supply unit provided with the device.
Power Supply units for different models are not
interchangeable.
5. Check the LEDs
•
The Red Error LED should flash, then turn Off. When the
Error LED goes off and the ACT LED remains lit or flashes,
the Wireless Print Server is ready.
•
For model SMC2621W-U, the Red Error LED will remain
flashing if the Wireless Print Server can't connect to the
USB printer.
•
The LAN LED should be ON.
(The WLAN LED will be Off. This is normal, see the
explanation above.)
10
This will disable the Wireless interface. The Wireless
interface cannot be used for initial configuration.
•
After configuration, the LAN interface can be
disconnected if not required.
•
To use both the LAN and Wireless interfaces, the
Wireless mode must be changed to "Ad-Hoc".
•
To use the LAN interface, the LAN cable needs
to be inserted BEFORE powering ON.