Advertisement
Available languages
Available languages
Physical Installation
1. Make sure the Print Server and Printer are powered OFF.
2. Connect the printer to the Print Server's printer port.
3. Use a standard LAN cable to connect the LAN port
on the Print Server to a 10BASE-T or 100BASE-T hub.
Note: Initial configuration cannot be performed via the Wireless
interface. After configuration, the LAN interface can be disconnected
if not required.
To use BOTH the LAN and Wireless interfaces, the Wireless mode
must be changed to Ad-Hoc.
4. Connect the supplied Power Adapter, power up both the
Printer and Print Server and check the Printer Server LEDs:
• The Error LED should flash, then turn off. If it stays on,
there is a hardware error.
• On models with one USB port, the Error LED will remain
flashing if there is no connection to the printer.
3
Configure Print Server
1. Insert the supplied CD-ROM into your drive. If the setup program
does not start automatically, run Autorun.exe in the root folder.
2. On the first screen, shown below, click [Setup Wizard].
3. Click [Next] on the first screen, to view a list of Print Servers
on your LAN.
4. Select your new Print Server, then click [Next] to continue.
5. Enter the required data on the [Print Server] screen.
• Name can be changed if you wish.
• Comment is optional.
• Select or enter the Workgroup name.
• You can enter a name for each Printer.
6. Click [Next] to configure the [TCP/IP] screen.
• Select [Obtain IP Address automatically] if your LAN has a DHCP
Server, otherwise select [Fixed IP Address].
• For Fixed IP Address, enter an unused address from the range
used on your LAN, or click the [Suggest New Values] Button.
Use the same [Network Mask] and [Gateway] as PCs on your LAN.
4
Advertisement
