Advertisement
This Quick Install Guide contains brief instructions for the
following environments:
Windows 95/98/ME/NT/2000/XP Peer-to-Peer Networks
•
•
Macintosh (AppleTalk)
IEEE 802.11b Wireless LANs
•
For other environments, or any problems, please refer to the full
User Manual in the Manual folder on the CD-ROM.
Physical Installation
1. Ensure the power is OFF.
!
a) For those using the Wireless PCMCIA adapter SMC2632W V.2
please follow the installation instruction:
Insert your Wireless card SMC2632W V.2 into the PCMCIA slot on the
Print Server until it encounters some resistance. Push firmly and it
will click into position.
If you are using a different wireless adapter of a different provider,
please refer to the full installation guide on the CD-Rom.
!
b) If you don't use a wireless connection, continue with the
described installation below for wired LAN connection
2. Connect the printer to the Print Server's printer port.
3. Use a standard LAN cable to connect the LAN port on the Print
Server to a 10BASE-T or 100BASE-T hub.
This will disable the Wireless interface, because the default
•
"Infrastructure mode" wireless setting can NOT be used with
the LAN interface.
After configuration, the LAN interface can be disconnected
•
if not required.
To use both the LAN and Wireless interfaces, the Wireless
•
mode must be set to "Ad-hoc".
4. Connect the supplied Power Adapter, power up and check the LEDs:
The Error LED should flash, then turn off. If it stays on,
•
there is a hardware error.
The LAN and WLAN LEDs will flash when data is transmitted
•
or received.
Setup using Windows
1. Insert the supplied CD-ROM into your drive. If the setup program
does not start automatically, run SETUP in the root folder.
2. Run the Setup Wizard by using this option on the first screen
3. In the Wizard, select the correct Print Server, click Next, and
step through the Wizard.
Wireless LAN Settings
The Print Server's Wireless settings must be correct:
Mode
If using an existing IEEE 802.11b Access Point, select
"Infrastructure" mode.
If you have no Access Point, select "802.11b
Ad-hoc" mode.
Channel In Ad-hoc mode, set this to the same value as the other
Wireless stations. (Not required in Infrastructure mode.)
SSID
The SSID should be set to match the other Wireless
stations (Ad-hoc mode) or the Access Point
(Infrastructure mode).
WEP
WEP settings should be set to match the other Wireless
stations (Ad-hoc mode) or the Access Point
(Infrastructure mode).
Advertisement
