Honeywell Home Wi-Fi Series User Manual page 32

Connecting to your Wi-Fi network
3 Make sure your thermostat is connected.
While the connection is in process, your
thermostat will flash Wait for up to 3 minutes.
When the connection is complete, the display will
show Wi-Fi Setup Connection Success. The Wi-Fi signal
strength will appear in the top-right corner.
After about 60 seconds, the home screen will
appear and Register at Total Connect will flash until
registration is complete.
If you don't see these messages, see page 26.
To register online for remote access to your
thermostat continue on page 31.
Note: If the thermostat displays Connection Failure or continues to display Wi-Fi
Setup, confirm you correctly entered your home network password in step 2. If
correct, refer to the FAQ at honeywellhome.com/support
69-2803ES—05
30
M33875
M33876