Boiler Cleaning - Frank bSteam bS25 Operating Instructions Manual

PERIODICALLY:
Periodically check that the power cord does not show signs of wear or aging. If it is
damaged, it is absolutely necessary to get it replaced by specialized personnel before
being able to re-use the appliance again.
12.

Boiler cleaning

Clean the boiler in our authorized centers once a year.
RINSE: It's recommended at least every 50 hours of operation or 4 months.
a) DISCHARGE:
The machine must be cold or definitely discharged from the steam pressure and
the plug disconnected. Open it by pulling the rubber cap placed under the
machine in correspondence of the boiler (see image below) and with an allen
wrench 6mm open the drain plug, shake slightly the machine to let the water
and the completely dissolved limestone out. When the boiler is empty, clean
and close carefully the cap tightening it with the wrench.
b) FILLING:
Fill the water tank (3), turn the machine on and make it start again, waiting for
the boiler to be recharged again.
(Note: it may be that during the first charge cycle, the "end of water" light turns
on and you need to shut down/restart the machine to complete the load)
13