Frank bSteam bS25 Operating Instructions Manual page 24

The machine starts heating.
Choose the most suitable accessory for the needed use and connected it to the
multifunction handle, by means of the extension tubes, then insert the hose
connector as shown by the white arrow in the picture.
When the machine is ready, to release steam through the handle of the flexible, press
the lever button (6). Now use the brush or accessory in the surfaces to be cleaned.
Attention: it is recommended to perform the first release of steam after the heating on
a container for about a minute, this is to collect any condensate water generated in the
initially cold ducts.
Attention: if you are working on delicate surfaces or things, keep the steam jet at an
adequate distance of at least 20-40cm.
STEAM RELEASE REGULATION:
Through the regulation knob (4) placed frontally on the machine, you can gradually
adjust the release of the steam.
END OF WATER:
The acoustic and the visual indicator of the display (2), indicates when there is no
more water inside the tank by showing "H2O", this is why the machine will stop the
steam release.
> 20 cm
9