Control Panel; Preparation And Start To Use - Frank bSteam bS25 Operating Instructions Manual

8. Control panel

3
2
1
•
1 General switch
•
2 Display
•
3 Water-filling cap
• 4 Steam adjustment knob
•
5 Connector block for hose

9. Preparation and start to use

Open the cap (3) and fill the tank with tap water
- Note: If the water available should be "very hard"(>20°F), It is recommended
the use of 50% demineralized water or distilled water, (this to avoid excessive
limestone formations and to be sufficiently conductive)
Attention: Do not add detergents, anti-limestone solutions or essential oils in
the water tank boiler, these can cause irreparable damage to the boiler and
circuits.
The manufacturer is not responsible for any damage caused by improper use.
Connect the plug to a socket on an electrical interconnection conformed to the
rules of the country, equipped with a switch and an earth terminal efficient.
START TO USE:
Turn the main switch on (1).
The display (2) will turn on and indicate the temperature-pressure status of the
machine, when the machine is ready, it will visualize "170". (usually the machine
needs around 2÷3 minutes to be ready.)
4
5
8