Shutdown Instructions; Storage Instructions - Hotsy 1.109-691.0 Dealer's Manual

Hot water - gas fired
Table of Contents

Advertisement

Operations

Shutdown Instructions

To Stop
1. If detergents were used, draw clear water through
the detergent line to purge detergent. Failure to do
so may clog detergent injector valve.
2. If burner was used, turn OFF burner switch and
allow pump to run cold water through coil for
several minutes.
3. Turn pump switch OFF.
4. Turn water supply OFF.
5. Squeeze trigger gun open to relieve system
pressure.
6. Depress gas control knob slightly and turn to OFF
position.
7. Turn off main shut-off valve on gas supply.
20
Hotsy 900/1400 Series Dealer Manual 9.803-324.0 - AW

Storage Instructions

DANGER: Do not store flammable liquids (gasoline,
diesel fuel, petroleum, solvents, etc.) near pressure
washer, or in non-ventilated areas.
DANGER: Ne pas entreposer de liquides
inflammables (essence, mazout, pétrole, solvants,
etc.) à proximité de la laveuse à pression ou dans
des endroits non ventilés.
IMPORTANT: Machine must be stored indoors.
1. Protect from freezing by storing in a heated area,
or by flushing the system with antifreeze (use an
automotive engine antifreeze or windshield washer
solvent to antifreeze). To flush the system fill the
float tank with antifreeze and remove pressure
nozzle from wand. Start the machine and allow it to
run until antifreeze runs from the end of the wand.
Place wand into float tank and circulate the solution
through system for several minutes. Open and
close the trigger gun several times to circulate anti-
freeze through the unloader valve system. Also
draw antifreeze through the detergent inlet line to
antifreeze the detergent system. For added protec-
tion after anti-freezing, disconnect the pressure
hose from machine and remove the coil drain plug
(refer to Component Identification illustration for
location). After coil has drained, replace pressure
hose and coil drain plug. If the pressure washer is
not to be used for an extended length of time, it is
recommended that the system be flushed with anti-
freeze for rust protection.
WARNING: Unauthorized machine modification or
use of non-approved replacement parts may cause
personal injury and/or property damage and will
void the manufacturer warranty.
AVERTISSEMENT: Une modification non autorisée
de la machine ou l'utilisation de pièces de
rechange non approuvées peut causer des lésions
corporelles et/ou des dommages à la propriété, et
annulera la garantie du fabricant.

Advertisement

Table of Contents
loading

Table of Contents