Control Panel; Operating From The Control Panel - Black & Decker BPACT14H Series Instruction Manual

SET UP & USE

CONTROL PANEL

Selected Mode
Indicator Light
Mode Selection
Button
Decrease Temp/Time
Button
Pictures are for illustration purpose only. Your model may or may not have all the features.

OPERATING FROM THE CONTROL PANEL

The Control Panel enables you to manage all the main functions of the
appliance, but to fully exploit its potential, you must use the remote
control unit.
TURNING THE APPLIANCE ON
• Plug into the dedicated electrical outlet. Two lines appear on the display
indicating that the appliance is in standby. (Fig. 6)
• Press the
it was turned off will appear.
* Never turn the air conditioner off by unplugging from the mains. Always press
the button
appliance to perform a cycle of checks to verify operation.
Note: Before pressing Power On button make sure the condensate drain plug in
the rear of the unit is securely in place to avoid any leaking.
• Press the MODE button until the light corresponding to the required Mode
lights up.
Page 12 Page 12
button until the appliance comes on. The last function active when
, then wait for a few minutes before unplugging. This allows the
Display Area
ON/OFF
Increase Temp/Time
Button
Fan Speed
Indicator Light
Fan Speed
Selection Button
Fig. 6