Black & Decker BPACT14H Series Instruction Manual page 13

SET UP & USE
COOL MODE
Ideal for hot muggy weather
when you need to cool and
dehumidify the room. To set
operation of the appliance
correctly, press the
until the desired temperature is
displayed. (See Fig. 7)
Then select the fan speed by pressing
the Fan Speed Button until the light
corresponding to the required fan
speed lights up:
HIGH: The Fan operates at maximum
to reach the required
temperature as rapidly as
possible.
MED: Reduces Fan noise level but
still maintains a good level of
comfort.
LOW: For quiet operation.
AUTO: The appliance automatically
selects the most suitable
fan speed in relation to the
temperature set on the digital
display.
DEHUMIDIFYING MODE
Ideal for reducing humidity
in spring and autumn, during
rainy spells or in damp rooms,
etc.
In dehumidifying mode, the appliance
must have the same configuration
as for the air conditioner mode, with
the air exhaust hose fitted to the
appliance to allow air to be discharged
externally.
When the dehumidifying mode is
selected, the light comes on and "dh"
appears on the display. (See Fig. 8)
At the same time, the AUTO fan light
comes on. In this mode, other fan
speeds cannot be selected.
26
Fig. 7
or buttons
dh
Fig. 8
FAN MODE
Adjust fan speed by pressing
the Fan Speed button as
described for the cool mode.
In this mode, AUTO fan cannot be
selected.
The fan speed selected will show in the
display. One row for Low, Two rows
for medium and three rows for high.
(See fig. 9)
HEAT MODE
Press the MODE button until the
HEAT mode indicator light appears.
Select the target temperature by
pressing the
the corresponding value is displayed.
(Temperature range is 55˚to 81˚F).
Then select the fan speed by pressing
the Fan Speed Button until the light
corresponding to the desired fan
speed lights up: HIGH, MED, LOW,
AUTO.
NOTE: At the beginning of this mode,
you may have to wait a few seconds
before the appliance starts to give out
hot air.
In HEAT mode there will be water
removed from the air and collected
in the tank, when the tank is full,
the appliance shuts down and "ft"
(FULL TANK as mentioned in SELF-
DIAGNOSIS appears on the display,
the tank must be emptied, then the
appliance will start up again. When
operating in very cold rooms, the
appliance defrosts automatically,
intermittently interrupting normal
operation. During the defrost
operation "Lt" (LOW TEMPERATURE
as mentioned in SELF-DIAGNOSIS)
appears on the display. The fan wil
continue working for a few seconds to
lower the interior temperature even
after the appliance shuts off.
In this mode, the fan may operate for
short periods even though the set
temperature has been reached.
Fig. 9
or button until
Page 13