Startup - Graco LineLazer 3000 Instructions-Parts List Manual

Gasoline-powered airless linestriper
Hide thumbs Also See for LineLazer 3000:
Table of Contents

Advertisement

Before You Start the LineLazer
1. See Flushing on page 17 to determine if you
should flush the LineLazer.
2. Be sure the gas tank is full.
3. Check the engine oil level.
NOTE: The engine stops automatically, or will not
start, if it is low on oil. Refer to the oil fill procedure in
the Honda engine manual or to step 3, page 6.
4. Be sure the spark plug cable is firmly pushed
onto the plug.
Starting the LineLazer
NOTE: Refer to Fig. 1 as you start the sprayer.
1. When starting a sprayer that IS NOT PRIMED,
remove the spray tip.
2. Place the suction tube into the paint, water or
solvent container, depending on whether you are
flushing or are ready to spray.
3. Detach pressure drain valve (V, Fig. 1) from
suction tube and place pressure valve drain tube
in another bucket.
4. Open the black fuel shutoff lever by pushing it in
the direction of the arrow.
CAUTION
Never try to start the engine unless fluid pressure is
relieved and the pressure control switch is OFF.
Trying to start the engine when it is pressurized
could damage the recoil system.
5. Move the pressure control switch to OFF.

Startup

6. To start the engine:
a. Turn the pressure adjusting knob all the way
counterclockwise to the lowest pressure set-
ting.
b. Slide the metal throttle lever away from the
fuel tank to maximum position (fully left).
c. If the engine is cold, close the choke by mov-
ing the gray lever to full choke.
d. If the engine is warm, close the choke by
moving the gray lever only half way or not at
all.
e. Turn the engine switch to ON.
f.
Hold the frame of the sprayer with one hand
and pull the starter rope rapidly and firmly.
Continue holding the rope as you let it return.
Pull and return the rope until the engine starts.
g. Open the choke as soon as the engine starts,
except in cold weather. In cold weather, leave
the choke closed for 10 to 30 seconds before
opening it to keep the engine running.
7. Unlock the gun trigger safety.
8. Release the trigger cable and engage the gun
trigger safety latch.
9. Remove the gun from the holder by unscrewing
the gun holder knob and lifting out the gun.
WARNING
MOVING PARTS HAZARD
A rope which recoils too quickly may hit
someone and cause serious injury. The
rope could also jam in recoil assembly.
308685
9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gm3000232650233010

Table of Contents