Table of Contents
Advertisement
CAUTION
To avoid damaging the pressure control, which may
result in poor equipment performance and component
damage, follow these precautions.
1. Always use nylon spray hose. Never use a wire
braid hose; it is too rigid to act as a pulsation
dampener.
2. Always use a minimum hose length of 25 foot
(7.5 m) x 1/4 inch ID or 25 foot (7.5 m) x 3/8 inch
ID hose.
3. Never install any shutoff device between the filter
(120) and the main hose. See Fig. 2.
1. Connect hose and gun. (Refer to Fig. 2.)
a. Remove the plastic cap from the 1/4 npsm (m)
filter outlet nipple (A). Screw the main fluid
hose onto the nipple. Read the CAUTION,
above.
b. Connect the hose between the main fluid hose
and the inlet adapter of the gun.
c. Do not use thread sealant, and do not install
the spray tip yet!
WARNING
If you replace your hoses and spray gun, be sure
the hoses are electrically conductive, that the gun
has a tip guard, and that each part is rated for at
least 3000 psi (207 bar, 21 MPa) Maximum Work-
ing Pressure. This is to reduce the risk of serious
injury caused by static sparking, fluid injection or
over-pressurization and rupture of the hose or gun.
6
308685
Setup
2. Fill packing nut/wetcup. Fill the packing nut/wet-
cup (B) 1/3 full with Graco Throat Seal Liquid
(TSL), supplied. See Fig. 2.
3. Check the engine oil level. Refer to the Honda
engine manual, supplied. This is a summary of the
information: Remove one of the oil fill plugs (M);
the oil should be almost overflowing. See Fig. 3.
Add oil as necessary.
Recommended lubrication oil: Use a high-quality,
detergent oil, SAE 10W–30, classified "FOR
SERVICE SG or SF", for regular use and for
breaking–in a new engine.
A 1/4 npsm(m) fluid outlet
120 Fluid Filter
B Wetcup
Fig. 2
120
A
B
06918B
Advertisement
Table of Contents
