Table of Contents
Advertisement
OPERATION
Pre-Operation Check
nFuel/Water Separator
Visually inspect the bowl for water collected at
the bottom of the bowl (1). (See illustration). If
water is present it will appear as a clear liquid at
the bottom of the bowl. Turn off fuel valve and
remove bowl by turning counterclockwise. Take
care not to spill fuel while removing. Wipe up
spills immediately with a shop cloth. Dispose of
fuel properly and follow all gasoline handling
precautions as outlined on page 49. Re-install
1
separator bowl making sure the O-ring is in
place. Hand tighten securely.
NOTE: The fuel/water separator is located
either under the front compartment door behind
the storage bucket on the starboard side or inside
the engine compartment. See illustration. Inspect
only when the watercraft is not on water.
NOTE: The fuel/water separator is integral to the fuel pump module
on Direct Injected models. It is not serviceable.
1. Deck
1
2. Fuel/Water Separator
2
64
Advertisement
Table of Contents
