Polaris Freedom 2002 Owner's Safety And Maintenance Manual page 122

MAINTENANCE AND LUBRICATION
Minor Maintenance
NOTE: During charging, if the electrolyte temperature rises above
115°F (45°C) reduce the charging rate to lower the temperature.
Increase the charging time.
3. After the battery is charged, check the fluid level. If it has dropped
add distilled water to bring the electrolyte up to the proper level.
4. Check the results of charging. The specific gravity of each cell
must be 1.26 at room temperature. The voltage should be 14.5 -
15.5 V during charging; 12.2 -12.8 V after charging.
Battery Installation
Always connect battery cables in the order specified. Red (positive)
cable first, black (negative) cable last.
1. Install the battery in its
holder.
2. Install the battery vent
tube. It must be free from
obstructions and securely
installed. If not, battery
gases could accumulate
and cause an explosion.
Avoid skin contact with
electrolyte, severe burns
could result.
3. First connect and tighten
the red (positive) cable.
4. Second connect and tighten the black (negative) cable.
5. Apply dielectric grease PN 2871066 to each cable.
6. Reinstall the battery cover and electrical box over the battery and
reconnect straps.
120
Top View of Battery
Black (-)
Vent
Tube
Red (+)