Table of Contents
Advertisement
Pre-Operation Check
nHull
Inspect the hull for cracks or damage. Do not ride the watercraft if the
hull is damaged. Remove marine growth if present using non-abrasive
cleaner.
nDrain Plugs/Bilge
To remove the drain plug turn
the plug counterclockwise until
loose and remove. To install,
clean the plug and plug hole of
sand and debris, insert the plug
and turn clockwise until tight.
NOTE: Some models have
more than one drain plug.
While the watercraft is out of
the water remove the drain plug.
Carefully flush out the bilge
with fresh water. Allow the
bilge to drain completely. Wipe
out the bilge with dry shop
cloths and reinstall the drain
plug.
Once the watercraft is launched,
remove the seat, and check for
leaks.
n Loose Straps/Ropes/Clothing/Long Hair
Be sure there are no loose straps, ropes, cords or belt-like objects
hanging from the watercraft or riders. Long hair should be tied back
and secured.
Make certain any long straps, ropes, clothing, long hair or anything
similar are tied back and secured.
These objects can become tangled in the jet pump impeller and
cause severe injury or death.
Keeper
Strap
O-Ring
Bilge Plug Assembly
WARNING
OPERATION
Gasket
Plug
61
Advertisement
Table of Contents
