Table of Contents
Advertisement
Pre-Operation Check
nSwitches/Buttons
When the watercraft is in the water perform the following checks:
S Pump water out of the engine compartment using the bilge pump
(gray button). Refer to page 34 for more information. Look inside
the engine compartment for fuel or water leaks and have them re-
paired if present. Do not ride the watercraft until leaks are repaired.
S Start the engine and let it run for a few seconds. Remove the lan-
yard lock plate from the engine shut-off switch. The engine should
stop immediately. If it doesn't, press the stop button or pull the
choke lever knob the engine dies. Do not ride the watercraft, and
have it serviced by an authorized Polaris dealer before riding it
again.
S Start the engine again and run it for a few seconds. Then depress
the engine "stop" button until the engine stops.
1. Lanyard
3. Lock Plate
5. Bilge
7. Stop Button
5
4
2
1
OPERATION
6, 7
3
2. PERCt (If Equipped)
4.
Forward
6. Start
63
Advertisement
Table of Contents
