Emerson BBCF370 Owner's Manual page 22

8. Wall Control Installation
Skip to Section 8.4 if Using a 3-way Switch
Installation.
SINGLE-POLE INSTALLATION
(One Fan Controlled by One Wall Control)
(See Figure 34).
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse or circuit breaker box before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
8.3
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install
the Ceiling Fan Wall Control into the Wall Box.
Before installing Wall Control, place Wall Control in
"OFF" mode by pushing "ON/OFF" Switch (
to the "OFF" ( O ) position.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
Connect the Wall Control Black Wire labeled
"TO POWER SUPPLY" to the "HOT" 120V AC Supply
Source Wire. Securely connect Wires with Wire
Connector, supplied (Figure 34).
Connect the Wall Control Black Wire labeled "TO FAN"
to the "LOAD" Black Wire in Wall Box. Securely connect
Wires with Wire Connector, supplied (Figure 34).
Connect the Wall Control Green Ground Wire to
the Supply Ground Conductor (this may be a Bare
Copper Wire or Wire with Green Colored Insulation).
Securely connect Wires with Wire Connector, supplied
(Figure 34).
WARNING
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
(Continued)
SCREWS (2)
....
OFF
ON
DECORATIVE WALL PLATE
HOT BLK
GND
)
NEUTRAL
RECEIVER LOCATED WITHIN
THE CEILING COVER
Figure 34
Screw Wall Control into Wall Box using the supplied
Screws. Leave Wall Control in "OFF" mode until Fan
installation is completed.
The Wall Control is supplied with a White, Ivory, and
Almond color Switch Covers. Choose the finish that
best suits your needs and snap the Cover onto the Wall
Control (Figure 34).
Install Decorative Wall Plate using the two Screws
supplied with Wall Plate. Leave the Wall Control in
"OFF" mode until Fan installation is completed
(Figure 34).
22
FAN/LIGHT WALL
CONTROL
....
OFF
ON
NEUTRAL
SWITCH COVER
WIRES
FAN/LIGHT
WALLCONTROL
....
BLACK
OFF ON
GROUND
WALL
BOX