Emerson BBCF370 Owner's Manual page 19

6.4
Carefully tuck all the Wires and Connectors into the
Lower Housing.
Position the LED Light Fixture Assembly onto the
Lower Housing, aligning the Three Holes.
NOTE: Verify that the wires and connectors are not
trapped between the LED light fixture assembly and
the lower housing.
Install and tighten the Three #6-32 x 1/4" Pan Head
Screws with Lockwashers (supplied) to complete
the installation of the LED Light Fixture Assembly
(Figure 30).
A spare #6-32 x 1/4" Truss Head Screw with
Lockwasher is supplied in parts bag, if needed.
WARNING
!
To avoid possible fire or shock, do not pinch wires
between the lower housing and the LED light fixture
assembly.
6.5
Place the Shade into the opening in the Lower Housing,
aligning the Three Flat Areas on the top edge of the
Shade with the Lower Housing Three Raised Dimples
and turn the Shade Clockwise until it stops (Figure 31).
NOTE: Periodically check that the Shade is seated
fully clockwise in the Lower Housing.
LOWER
HOUSING
LED LIGHT
FIXTURE
ASSEMBLY
#6-32 x 1/4" TRUSS
HEAD SCREWS WITH
LOCKWASHERS (3)
Figure 30
LOWER
HOUSING
RAISED
DIMPLES (3)
Figure 31
19
FLAT AREAS (3)
ROTATE CLOCKWISE
SHADE