Continuous Forms Printing - SATO CX400 Programming Reference Manual

Continuous Forms Printing

Command Structure
Command Function
Input to Printer
Printer Output
Special Notes
Page 2-20
None
The printer locates the end of an adhesive label by sensing the backing
between labels or through the use of an eye-mark (black rectangle on the
reverse side of the backing). It locates the end of a tag from a notch, eye-
mark, or a hole between tags. Both sensors should be disabled when
printing continuous forms by sending the <ESC>CI0 command to disable
the sensor.
<ESC>A
<ESC> CI0
<ESC>H100<ESC>V50<ESC>XMContinuous Forms Printing
<ESC>Q3<ESC>Z
1. If you will be using continuous labels or tags, the printer must be told
to stop feeding in another manner. The length is determined by the
position of the last printed image on the label or tag. The printer will
stop feeding when this last field is finished printing. The length may
be increased with printed spaces (20
mand code to control label length.
PN 9001106 Rev. A
Section 2: Command Codes
) if necessary. There is no com-
H
SATO CX400