Whirlpool Maytag MVWP576KW Technical Manual page 21

Drain and Spin Cycle
To access the Drain and Spin Cycle, perform steps 1 and 2 of Activating
the Service Diagnostic Test Modes. Toggle the cycle selector knob until
the status LEDs correspond as follows:
n "RINSE and DONE" LEDs On
FILL SOAK/
Wash
Press the START button to start the Drain and Spin Cycle.
UI Test Mode
To access UI (User Interface) Test Mode, perform steps 1 and 2 of
Activating the Service Diagnostic Test Modes. Toggle the cycle selector
knob until the status LEDs correspond as follows:
n "RINSE and FINAL SPIN" LEDs On
(1)FILL (2)SOAK/
Wash
NOTE: Status LED names may vary between makes and models. Use LED
number identifications.
Press the START button to begin the UI test.
n Upon entering the UI test mode, all status LEDs will be turned ON.
n Pressing the START button will turn on and off all status LEDs, or
toggle the state of each status LED independently. (Example: If 2 are
on, and 3 are off, then 2 will be turned off and 3 turned on.)
n When toggling the cycle selector knob, each double click will toggle
the "DONE" (5) LED.
n Turning the rotary switch will toggle the following status LED on and
off.
n (1) FILL LED
n Press and hold the START button for 3 seconds.
n Washer will exit UI test mode after 5 minutes of inactivity or
unplugging the power cord.
For Service Technician Use Only
RINSE FINAL
SPIN
(3)RINSE (4)FINAL
SPIN
Maytag
DIAGNOSTICS AND TROUBLESHOOTING (Cont.)
Software Version Display Mode
To access Software Version Display Mode, perform steps 1 and 2
of Activating the Service Diagnostic Test Modes. Toggle the cycle
selector knob until the status LEDs correspond as follows:
n "RINSE, FINAL SPIN, and DONE" LEDs On
DONE
FILL
NOTE: Status LED names may vary between makes and models.
Press the START button to begin software display mode.
n Upon entering the software version display mode, the Major,
Minor, and Test version numbers for the software are displayed by
alternating the state of the Status LEDs in one second intervals; the
process repeats following a pause.
To calculate the number being displayed, add the
representative numbers together that are displayed at the
same time; see chart below for representative numbers.
(5)DONE
For example, if the s/w version is 02.01.07, the following
sequence would be displayed:
16
FILL
n Press and hold the START button for 3 seconds at any time to exit
software version display mode.
Factory Diagnostics
This is for factory use only, as it runs the Factory Cycle Template
for testing the washer before it leaves the factory.
3.5 cu.ft. Commercial-Grade Residential Agitator Washer
®
SOAK/ RINSE
Wash
8 4 2
SOAK/ RINSE FINAL
Wash SPIN
FINAL DONE
SPIN
1
02
01
07
DONE
2-7
n