Advertisement
June 2021© Toro Groundsmaster 360 ROPS Cab Installation Manual
12. Once all fasteners are started, and cab is fastened to tractor, un-hook the cab lift brackets
and then remove the brackets from the cab.
13. The 5/8" rear fasteners can be tightened to a 205 ft-lb torque. The ½" front fasteners can
be tightened to a 100 ft-lb torque.
14. Route the wiring harness under the hood. The black wire needs to be connected to a
tractor ground, use the provided 1/4" loop. Shorten wire if necessary, then solder connector to
wire. The heavy red wire gets connected to the alternator with provided 1/4" loop. Shorten
the wire if necessary, then solder connector to wire. The orange wire is a switched source wire
(white in photo on following page), and must be connected to a key switched activated wire on
the alternator. Solder cab wire directly to this tractor wire.
Switched
Main Power
Advertisement
