Advertisement
June 2021© Toro Groundsmaster 360 ROPS Cab Installation Manual
21. Use provided zip ties to down hoses to prevent contact with moving parts in the engine.
22. Make sure all fitting connections are tight and the hoses are properly secured to the
machine. Re-fill the engine antifreeze. Go to the cab, and turn the heater control switch to the
maximum heat side. Start the engine and turn the cab fan to the highest speed setting. Take
the radiator cap off of the engine and place a funnel into the radiator. Fill the funnel with
antifreeze. The engine will need to run for a few minutes and the thermostat open a few times
in order for all air to be purged from the heater system. The air at the cab louvers should be
very hot when that occurs. NOTE: ensure adequate fresh air ventilation in the work space you
are in, carbon monoxide from the engine exhaust is deadly.
23. Take the 3 pieces of floormat. We recommend using an aerosol spray glue, 3M High
Strength90. One piece goes onto the near vertical face of the seat platform. One piece goes on
the horizontal floor, and the remaining piece goes on the angled floor. Ensure pedals have full
range of motion, notch if necessary. Glue into place.
Advertisement
