Advertisement
June 2021© Toro Groundsmaster 360 ROPS Cab Installation Manual
7. Take one of the ½" x 4 ½" hex bolts and one cab lift bracket. Locate the top rear corner of
the left b-post where the weld nut is located. Fasten the bracket to the weld nut. Repeat for
the right side.
8. Attach a chain or lifting strap to both cab lift brackets and connect to an over head crane or
forklift. Un-bolt the front and rear shipping brackets and lift the cab up off of the shipping
pallet.
9. Position the cab directly over the machine and slowly lower down until front mount plate is
contacting the foot platform and rear mount holes line up with bottom hole in 2-post ROPS.
10. Use the provided ½" x 2 ½" hex bolts and nuts for the front ROPS fasteners. Get the
fasteners started only. Do not tighten yet.
11. Use the provided 5/8" x 5" hex bolts, heavy flat washer and flange nuts for the rear isolator
ROPS fasteners. See photo for proper bolt alignment for the left and right sides.
Advertisement
