Table of Contents
Advertisement
Installing Cable Entry Cover
1.
Plan your installation carefully
2.
Drill a 32mmø hole in roof
3.
Prepare surface for adhesion
4.
Apply sealant as shown in A,B,C
(we recommend Sikaflex-512 Caravan)*
5.
Position top hat
6.
Position cable entry cover
7.
Wipe excess sealant with a dry cloth
Applying sealant example:
A
C
Direction of travel
(front of vehicle)
Installing Control Box
Having previously chosen a suitable location
1.
Clip the mounting brackets onto the Control Box
2.
Place Control Box on the horizontal or vertical surface & mark the 4 holes
3.
Depending on material drill a pilot hole or use a bradawl
4.
Attach cables to Control Box refer to page 11 for details
5.
Screw Control Box into position using 4 x No. 6 Screws
Mounting Positions
Position the Control Box in one of the 4 ways shown right.
Make sure that the front is easily accessible
Fitting the Control Box Brackets:
The brackets snap fit to the Control Box casing
Page 10
Hole location
tabs
Vehicle roof
B
32mm ø
= Generously apply
wet seal adhesive
Cable
Top hat
Advertisement
Table of Contents
