Fitting And Removing The Safety Net - Volvo XC90 TWIN ENGINE Owner's Manual

4. Hook the attaching brace's hook through the
load securing eyelet at the cargo floor from
underneath, and guide the threaded part
through the cargo grille's lower attachment
hole from underneath (1).
Slide a plastic sleeve on the threaded part of
the attaching brace - the sleeve flange
should face up - and guide it down through
the hole. Then screw on the screw cap until
its lower edge is approx. 5 mm from the grille
(2).
5. Repeat the steps in point 4 on the other
side.
6. Centre the safety grille and then tighten the
two attaching braces alternately until the
grille is properly secured.
Removal
Remove the safety grille by performing the above
steps in reverse order.
Note that the attaching braces can be removed
before the plastic sleeves are removed from the
holes in the grille.
Related information
•
Recommendations for loading (p. 587)
•
Load retaining eyelets (p. 589)
LOADING, STORAGE AND PASSENGER COMPARTMENT

Fitting and removing the safety net*

The safety net prevents loads from being thrown
forward in the passenger compartment in the
event of sudden braking.
The safety net is fitted into four mounting points.
For reasons of safety, the safety net must always
be fastened and anchored as described below.
The net is made of a strong nylon fabric and can
be secured two different locations in the car:
•
Rear fitting - behind second seat row.
•
Front fitting - behind the front seats.
WARNING
Loads in the luggage compartment must be
anchored well, and also using a correctly fit-
ted safety net.
}}
593
* Option/accessory.