Table of Contents
Advertisement
Available languages
Available languages
EN
plug is not located in an
accessible area after
installation, use a compliant
two-pole switch that assures
the complete disconnection
of the mains under over-
current category III
conditions, in accordance
with installation regulations.
WARNING!
sure that the mains power
cable has been installed
correctly before re-
connecting
the hood to the mains power
supply and making sure that
it works correctly.
The hood is provided with a
special power cable; if the
cable is damaged, request a
replacement from the
technical support
department.
Always make
Installation
Save these instructions
Mounting
Before installation:
• Make sure that the
product is of a suitable
size for the area in
which it is to be
installed.
• Remove the activated
carbon filter(s) if
supplied (see also
relative section).
This/these should be
reinstalled only if you
wish to use the hood in
the filter version.
• Make sure that (for
transport purposes)
there are no other
items inside the hood
(e.g. packets of screws,
guarantees etc.), which
should be removed
and kept.
• If possible, disconnect
and move any units
20
Advertisement
Table of Contents
