Table of Contents
Advertisement
ADD THE DETERGENT
ADD FABRIC SOFTENER
ADDING BLEACH
1. Measure the correct amount of powder or liquid detergent by
following the recommendations on the package.
2. Mix detergent in one litre of hot or warm water.
3. Add the pre-mixed detergent to the wash load.
Don't do these things:
* Using too little detergent will give you a poor wash result.
*
Using excessive detergent will create too much suds and may cause
overloading of the motor during the spin stage of the wash cycle. To avoid
excessive suds, reduce the amount of detergent you use. It is best to use
detergent labelled low sudsing. Good quality, front load detergent will
perform well in this machine.
* Use soap based products in your washing machine.
1. Measure the correct amount of fabric softener by following the
recommendations on the package.
2.
Mix softener with an equal amount of warm water but only mix enough to fill
to the line marked inside the cup. The softener cup holds 75ml.
3.
Pour the mixed softener into the cup in the top of the agitator. Do not
overfill the cup.
4. Do not spill fabric softener on the clothes as it may stain them.
IMPORTANT: If you are going to use fabric softener, you must select
the Deep Rinse option, i.e deselect the Eco Rinse option. Also if
softener is used frequently the machine must be flushed out
regularly refer Page 15.
NOTE: You do not have to use fabric softener, your washing machine
will wash the clothes perfectly well without it.
Bleaching of clothes can help to remove stains, heavy soiling and to kill bacteria.
Oxygen type - This is generally a powder type bleach. Mix the required quantity
with water and pour down the hole in the top panel during the fill when there is
some water in the wash bowl. Refer to the instructions on the bleach container.
Chlorine type - This type of bleach should NOT be mixed with detergent. Mix
the bleach with water as per the instructions on the container.
Turn Program Selector to a Regular Wash position.
Press the Start/Hold To Pause touchpad to commence water fill.
Pour the bleach solution down the hole in the top panel during fill when there
is some water in the wash bowl.
Allow the machine to agitate for a few minutes, then let it stand for the required
time by pressing and holding the Start/Hold To Pause touchpad for 1.2
seconds to pause machine.
Turn Program Selector to Drain & Spin position and press the Start/Hold To
Pause touchpad to empty the wash bowl.
You can now wash the clothes load using detergent and your selected wash
program.
NOTE: Bleach should NOT be used on silk, wool, rayon or drip dry clothes.
7
Advertisement
Table of Contents
