Cleaning Stains In The Wash Bowl; Avoiding Build Up Of Undissolved Detergent; For Your Safety - Westinghouse WWT6041 Manual

CLEANING STAINS IN THE WASH BOWL

Stains in the wash bowl can be caused by:
IMPORTANT:
IMPORTANT:
AVOIDING BUILD UP OF UNDISSOLVED DETERGENTS
If you only wash with cold water, undissolved detergent and body oils will build up in the washing machine.
This build-up can cause spotting on your clothes.

FOR YOUR SAFETY:

Check all pockets before loading clothes into your washing machine. Don't leave wet
clothing (especially swimwear) in the bowl for too long before you wash it.
How to clean the stainless steel wash bowl
Wipe with a cleaning product which is marked suit able for stainless steel.
Never use bleach cleaners or steel wool.
To avoid this build-up:
do not use too much fabric softener with cold water
select a hot water wash at least once a month
always dissolve the detergent in one litre of warm water.
What to do if there is spotting on your clothes
1. Put 250 grams of Epsom Salts into the wash bowl.
2. Fill the washing machine with HOT water and agitate for one minute.
3. Leave the water in the washing machine for 3 hours.
4. Agitate for 5 minutes.
5. Pump the water out.
6. Rinse the washing machine twice with cold water.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety.
Young children should be supervised to ensure that they do not play with the
appliance.
If this appliance is supplied from an extension cord or portable electrical outlet
device, the extension cord or portable electrical outlet device must be positioned so
that it is not subject to splashing or entry of moisture.
IMPORTANT:
If you have a mains pressure hot water service and it has not been used for two or
three weeks:
Before using the washing machine it is recommended that a hot water tap close to
the washing machine be turned on and the water allowed to flow for a couple of
minutes. This will allow any gas pressure that has built up over the period of non
use to be discharged.
For further details refer to your hot water service installation instruction and owners
guide.
metal objects such as bobby pins, dressmaking pins and nails.
salt
If the electrical cord of this appliance is damaged, it
must be replaced by the Manufacturer, Authorised
Service Agent or similarly qualified person in order
to avoid a hazard.
15