Using The Clock And Timer - Crosley XGF300 Owner's Manual

Using the Clock and Timer

Throughout this manual, features and appearance may vary from your model .
You have the choice of having the timer show the time
counting down or the time of day . In either case, the
timer will signal at the end of the timer period to alert you
that the time is up .
To Set the Clock
NOTE: When you first plug in the range or after a power
failure, the entire Clock/Timer display will light up .
1. Press the Clock pad .
2. Press and hold the + or – pad and the time of day
will change 10 minutes at a time . To change the
time by single minutes, give the pads short taps .
3. Press the Clock pad to start the clock .
To Set the Kitchen Timer
1. Press the Kitchen Timer On/Off pad .
2. Use the + and – pads to set the timer . Short taps on
the + or – pad change the timer's setting one minute
at a time . Pressing and continuing to hold the + pad
increases the setting 10 minutes at a time .
3. Once you have set your timer, press the Kitchen
Timer On/Off pad to start timing .
As the timer counts down, a signal will indicate
when one minute is left . After this signal, the display
will count down in seconds . When time runs out, a
final signal will sound . Press the Kitchen Timer On/
Off pad to stop the signal .
To Change or Cancel the Kitchen Timer Setting
When the timer is counting down, use the + and – pad
to change the remaining time, or press the Kitchen
Timer On/Off pad to stop the timer . The timer cannot
Display Clock While Kitchen Timer Is Operating
Pressing the Clock pad while the timer is operating will
not interfere with the timer's operation; the display will
change to show the clock, but the timer will continue to
49-2001080 Rev. 2
be cancelled unless you have fully completed "set timer"
instructions above .
count down and will still signal when time is up . Press
the Kitchen Timer On/Off pad again to change the
display back to show the timer .
9