Drainage Connection; Connection To Water Supply - Hisense HS693C60XADUK User Manual

Drainage connection

min.
14 mm
The drainage hose may be extended by a maximum of 3 m (the total length of the drainage hose must
not exceed 4.5 m). Any joins and connecting pipes must have an internal diameter of at least 14 mm.
However, the drainage hose should ideally be replaced with a new hose without joins.
No part of the drainage hose may be more than 950 mm above the bottom of the dishwasher. The
hose must not be routed directly to a floor drain or the like. In such cases, the hose can act as a siphon
and empty the dishwasher.
The hose must always discharge at least 350 mm above the bottom of the machine.
Attach the drainage hose with a hose clamp. Ensure that the drainage hose has no kinks.
NOTE!
When the drainage hose is routed to a connection nipple on the sink unit's water trap, the hose
must be attached at the same height as the underside of the sink unit (1), otherwise dishwater
from the sink may flow back into the dishwasher. There are other connection alternatives (2, 3).
The water trap must be ventilated.

Connection to water supply

Use only the inlet hose supplied with the dishwasher. Do not re-use old or other spare hoses.
The supply pipe must be fitted with a water tap (stopcock). The water tap must be easily accessible,
so that the water can be shut off if the dishwasher has to be moved.
38
max. 950 mm min. 350 mm