Directed DIRECTECHS HYUNDAI11 Installation Manual
  1. Manuals
  2. Brands
  3. Directed Manuals
  4. Automobile Accessories
  5. DIRECTECHS HYUNDAI11
  6. Installation manual
Directed DIRECTECHS HYUNDAI11 Installation Manual

Directed DIRECTECHS HYUNDAI11 Installation Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
INSTALLATION GUIDE
HYUNDAI11
Designed by Installers for Installers
© 2020 Directed, Vista CA
This product is intended for installation by a professional installer only! Attempts to install this
product by a person other than a trained professional may result in severe damage to a vehicle's
electrical system and components.
2020-03-31
Directed Digital
Solutions

Advertisement

Table of Contents
loading

Related Manuals for Directed DIRECTECHS HYUNDAI11

Summary of Contents for Directed DIRECTECHS HYUNDAI11

  • Page 1 HYUNDAI11 Designed by Installers for Installers © 2020 Directed, Vista CA This product is intended for installation by a professional installer only! Attempts to install this product by a person other than a trained professional may result in severe damage to a vehicle’s electrical system and components.

  • Page 2: Table Of Contents

    Contents Warning! Safety first ........................3 Introduction ............................ 4 Pre-installation and application warnings ..................4 Vehicle application guide ......................5 Wiring connections ......................... 6 Main power harness (H1), 12-pin thick gauge connector ............... 6 Auxiliary output harness (H2), 16-pin black connector ..............6 Analog harness (H3), 18-pin white connector ................

  • Page 3: Warning! Safety First

    The following safety warnings must be observed at all times: • Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. • When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an area that does not have adequate ventilation.

  • Page 4: Introduction

    Introduction The HYUNDAI11 firmware for Directed Digital Solutions is compatible with specific Hyundai and Kia vehicles. It is a complete solution for remote start, security (if applicable), bypass interface, and convenience. This guide provides information on the installation of the module using HYUNDAI11. If you would prefer using this system as a digital solution, go to www.directechs.com and search for the make, model and year of the vehicle.

  • Page 5: Vehicle Application Guide

    DL: OE Door Lock & Alarm Controls FOB: Sync CAN Interface w/ FOB Remote PK: Transponder & Immobilizer Override RS: Remote Start & Engine Controls SS: Integrated Security & Monitoring ST: Function/Feature Status Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.

  • Page 6: Wiring Connections

    If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. Note that they are low current and a relay may be necessary. Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.

  • Page 7: Analog Harness (H3), 18-Pin White Connector

    If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. The Green wire is only required for starter disable and anti-grind applications. Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.

  • Page 8: Installation (Wiring Diagram & Vehicle Wiring Reference Chart)

    (white conn., rear of Siren fuse box plug (E)) (+) Ignition: Red, pin 2 Ignition Interr.: (+) Starter: Pink, pin 12 EMS COM: Brown/Orange, pin 29 Yellow, pin 2 Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.
  • Page 9 B-CAN Low Black Data IGPM-Dash Fuse Box, rear plug (G). White D-CAN High White Data OBDII. Black D-CAN Low Yellow Data OBDII. Black Parking Light Blue Headlight, Wiper Switch. Black Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.

  • Page 10: Type 2

    IGPM - Dash Fuse Box (black conn., in IGPM - Dash Fuse Box fuse box plug (A)) (white conn., rear of fuse box plug (F)) EMS COM: Brown/Orange, pin 55 Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.
  • Page 11 Data IGPM-Dash Fuse Box, rear plug (G). White P-CAN High Orange Data IGPM-Dash Fuse Box, rear plug (G). White P-CAN Low Green Data IGPM-Dash Fuse Box, rear plug (G). White Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.

  • Page 12: Type 3

    IGPM - Dash Fuse Box driver kick panel) (white conn., rear of Siren fuse box plug (E)) Ignition Interr.: (+) Starter: Pink, pin 12 Yellow/Black, EMS COM: Brown pin 2 or Brown/Orange, pin 20 Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.
  • Page 13 Green Data IGPM-Dash Fuse Box, rear plug (G). White C-CAN High Data IGPM-Dash Fuse Box, rear plug (G). White C-CAN Low Blue Data IGPM-Dash Fuse Box, rear plug (G). White Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.

  • Page 14: Type 4

    I/P Junction Block (gray connector rear of fuse box plug (D)) (+) Starter: Red, pin 19 I/P Junction Block (black connector Ignition Interrupt: rear of fuse box plug (C)) Brown, pin 52 Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.
  • Page 15 Junction connector, behind I/P junction block. Green C-CAN Low Blue Data Junction connector, behind I/P junction block. Green Parking Light Green Headlight - Wiper Switch. Black Ignition I/P Junction Block, rear plug (C). Black Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.

  • Page 16: Connecting The Module

    Manual or automatic transmission selection The yellow loop on the Directed Digital Solutions controls which transmission type the unit is configured for. The state of the loop (uncut or cut) when the main module is powered up will determine which type is selected.

  • Page 17: Rf Systems

    When flashing the Directed Digital Solutions, make sure to pick the remote you will be using. This way the main module will have the necessary firmware to interact with the remote and Control Center (antenna) combination.

  • Page 18: Module Programming

    Connect all but the 12-pin harness Connect all the harnesses to the Directed Digital Solutions, EXCEPT the 12-pin main power harness. Connect the 12-pin main power harness, and wait until the LED turns ON solid red.

  • Page 19: Led Diagnostics And Troubleshooting

    External module synchronization Description Troubleshooting OBDII feature not supported. The diagnostic data bus was not detected, therefore the SmartStart features will be limited. (Flashes red, red, then orange) x 10 Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.
  • Page 20 The vehicle was detected as moving, which prevents the system from shutting it down. Flashes red x 4 Analog error codes Description Troubleshooting DEI feature error. A feature config file mismatch was detected. Please contact Technical Support. Flashes red, green & orange Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.

  • Page 21: Soft Reset

    A module reset will only erase the steps performed in "Module programming" on page 18. The firmware and settings flashed to the module will not be affected. Connect all but the If required for your installation, connect all the harnesses to the Directed Digital Solutions, 12-pin harness EXCEPT the 12-pin main power harness. Press and hold the programming button, then connect the 12-pin harness to the module.

  • Page 22: Learning The Tach (Not Needed With Virtual Tach)

    Important! After successfully learning Virtual Tach, a small minority of vehicle starters may over crank or under crank during remote start. Use the VirtualTach Fine tune feature in the configuration wizard to adjust the starter output time in 50mS increments to compensate for such an occurrence. Directed Digital Solutions HYUNDAI11 © 2020-03-31 Directed. All rights reserved.

  • Page 23: Limited Lifetime Consumer Warranty

    Directed dealer, the unit was professionally installed and serviced by an authorized Directed dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed dealer; and the unit is returned to Directed, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer’s name, telephone number and address;...

  • Page 24: Quick Reference Guide

    Factory remote. Press the Remote Start button on the transmitter.* • Aftermarket remote. • Directed SmartStart application via your smartphone. & The parking lights will flash once to indicate the Parking lights flash x1 Press Remote vehicle is now in Pit Stop Mode.
  • Page 25 SmartStart compatible This system is compatible with Directed SmartStart. For a complete list of supported features, please visit www.mysmartstart.com. What is SmartStart? Now you can remote start, lock and unlock your car just by pushing a button on your mobile device; using the SmartStart App from Directed, the leader in vehicle security and remote start.

Table of Contents