Directed Directechs HYUNDAI2 Installation Manual
  1. Manuals
  2. Brands
  3. Directed Manuals
  4. Automobile Accessories
  5. Directechs HYUNDAI2
  6. Installation manual

Directed Directechs HYUNDAI2 Installation Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
INSTALLATION GUIDE
HYUNDAI2
Designed by Installers for Installers
© 2019 Directed, Vista CA
This product is intended for installation by a professional installer only! Attempts to install this
product by a person other than a trained professional may result in severe damage to a vehicle's
electrical system and components.
2019-05-29
Directed Digital
Solutions

Advertisement

Table of Contents
loading

Related Manuals for Directed Directechs HYUNDAI2

Summary of Contents for Directed Directechs HYUNDAI2

  • Page 1 HYUNDAI2 Designed by Installers for Installers © 2019 Directed, Vista CA This product is intended for installation by a professional installer only! Attempts to install this product by a person other than a trained professional may result in severe damage to a vehicle’s electrical system and components.

  • Page 2: Table Of Contents

    Contents Warning! Safety first ........................3 Introduction ............................ 4 Pre-installation and application warnings ..................4 Vehicle application guide ......................5 Wiring connections ......................... 6 Main power harness (H1), 12-pin thick gauge connector ............... 6 Auxiliary output harness (H2), 16-pin black connector ..............6 Analog harness (H3), 18-pin white connector ................

  • Page 3: Warning! Safety First

    The following safety warnings must be observed at all times: • Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. • When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an area that does not have adequate ventilation.

  • Page 4: Introduction

    Keys required for compatible programming operation Hyundai2 vehicles do NOT support virtual tach, program data tech when using a Directed Digital Solution.. Š Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic Š...

  • Page 5: Vehicle Application Guide

    DL: OE Door Lock & Alarm Controls FOB: Sync CAN Interface w/ FOB Remote PK: Transponder & Immobilizer Override RS: Remote Start & Engine Controls SS: Integrated Security & Monitoring ST: Function/Feature Status Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 6: Wiring Connections

    If these outputs are not used by the firmware, they can be configured by the installer when the module is flashed. Note that they are low current and a relay may be necessary. Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 7: Analog Harness (H3), 18-Pin White Connector

    These connections are only required if the corresponding statuses are not supported by the firmware. See "Vehicle application guide" on page 5 for a list of compatible features. Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 8: Installation (Wiring Diagrams & Vehicle Wiring Reference Charts)

    15 1617181920 2122232425 Junction Box) 282930313233 3435363738 (+) 12V: Red, pin 2 I/P Junction Box (+) Starter: Yellow, pin 39 (Left Side of Dash Panel) (+) Ignition: Pink, pin 27 Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.
  • Page 9 Black Accessory Orange I/P-F, back of drivers I/P junction box. Black Starter Yellow I/P-F, back of drivers I/P junction box. Black EMS COM Brown/Orange Data EM11, drivers kick panel. White Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 10: Type 2

    Junction Box) (+) Starter: Yellow, pin 39 282930313233 3435363738 (+) 12V: Red, pin 2 I/P Junction Box (Left Side of Dash Panel) (+) Ignition 1: Pink or White, pin 27 Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.
  • Page 11 I/P-F, back of drivers I/P junction box or EM11, Black or Starter Yellow 39 or 40 39 or 58 F or G driver kick panel White Blue/Black or Brown/ EMS COM Data EM11, drivers kick panel. White Orange Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 12: Type 3

    1 & 7: White: (+) Accessory Output I/P-L White conn. I/P-L (I/P Junction box) I/P-M I/P-K I/P-N use Panel front (+) 12V: Red, pin 2 I/P Junction Box (left side of dash panel) Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.
  • Page 13 White Parking Lights Pink I/P-C, back of drivers I/P junction box. White EMS COM Blue Data EM11, drivers kick panel. White Driver Door Trigger Brown MF11, drivers kick panel. White Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.
  • Page 14 White Parking Lights Pink I/P-C, back of drivers I/P junction box. White EMS COM Blue Data EM11, drivers kick panel. Black Driver Door Trigger Brown MF11, drivers kick panel. White Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 15: Type 4

    6: Yellow: (+) Ignition Output (-) PTS 2 Output: Blue/White: 18 2 & 8: White/Brown: (+) 12V Input (-) PTS 2: Yellow/Orange,pin 7 1 & 7: White: (+) Accessory Output Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.
  • Page 16 Black Accessory Orange I/P-E, back of drivers I/P junction box. Black Starter Yellow I/P-E, back of drivers I/P junction box. Black EMS COM Blue Data EM11, drivers kick panel. White Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 17: Type 5

    (-) PTS 2: Siren Yellow/Orange, 6: Yellow: (+) Ignition Output pin 8 (-) PTS 2 Output: Blue/White: 18 2 & 8: White/Brown: (+) 12V Input 1 & 7: White: (+) Accessory Output Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.
  • Page 18 EM11, drivers kick panel. White Accessory Orange EM11, drivers kick panel. White Starter Gray EM11, drivers kick panel. White EMS COM Brown/Orange or Blue Data EM11, drivers kick panel. White Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 19: Type 6

    (-) PTS 2: Siren Yellow/Orange, 6: Yellow: (+) Ignition Output pin 8 (-) PTS 2 Output: Blue/White: 18 2 & 8: White/Brown: (+) 12V Input 1 & 7: White: (+) Accessory Output Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.
  • Page 20 Ignition Pink EM11, drivers kick panel. White Accessory Orange EM11, drivers kick panel. White Starter Green EM11, drivers kick panel. White EMS COM Blue/Orange Data EM11, drivers kick panel. White Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 21: Type 7

    (-) PTS 2 Output: Blue/White: 18 2 & 8: White/Brown: (+) 12V Input 1 & 7: White: (+) Accessory Output White conn. I/P-C (Front of I/P Junction Box, located left side of dash panel. Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.
  • Page 22 White I/P-E, back of drivers I/P junction box. White Starter Green I/P-C, back of drivers I/P junction box. White Black or EMS COM Blue/Orange Data EM11, drivers kick panel. White Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 23: Type 8

    2 & 8: White/Brown: (+) 12V Input (+) Accessory: Blue or White, pin 31 1 & 7: White: (+) Accessory Output White conn. I/P-E (Back of I/P Junction box, left side of dash panel.) Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.
  • Page 24 White Ignition Blue I/P-E, back of drivers I/P junction box. White Accessory Blue I/P-E, back of drivers I/P junction box. White Starter I/P-E, back of drivers I/P junction box. White Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 25: Type 9

    2 & 8: White/Brown: (+) 12V Input (+) Accessory: Blue or White, pin 31 1 & 7: White: (+) Accessory Output White conn. I/P-E (Back of I/P Junction box, left side of dash panel.) Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.
  • Page 26 Blue I/P-E, back of drivers I/P junction box. White Accessory Blue or White I/P-E, back of drivers I/P junction box. White Starter I/P-E, back of drivers I/P junction box. White Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 27: Type 10

    (+) 12V: Black conn. I/P-D Red, pin 1 (Front of I/P Junction Box, located on left side of dash panel) (+) Ignition 1: Green, pin 25 Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.
  • Page 28 Ignition 2 I/P-B, back of drivers I/P junction box. White PTS 1 Pink Smart Key Module harness, back of fusebox. PTS 2 Gray/Black Smart Key Module harness, back of fusebox. Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 29: Connecting The Module

    Manual or automatic transmission selection The yellow loop on the Directed Digital Solutions controls which transmission type the unit is configured for. The state of the loop (uncut or cut) when the main module is powered up will determine which type is selected.

  • Page 30: Optional Sensors

    When flashing the Directed Digital Solutions, make sure to pick the remote you will be using. This way the main module will have the necessary firmware to interact with the remote and Control Center (antenna) combination.

  • Page 31: Module Programming

    Connect all but the 12-pin harness Connect all the harnesses to the Directed Digital Solutions, EXCEPT the 12-pin main power harness. Must be connected LAST Connect the 12-pin main power harness, and wait until the LED turns ON solid red.

  • Page 32: Led Diagnostics And Troubleshooting

    External module synchronization Description Troubleshooting OBDII feature not supported. The diagnostic data bus was not detected, therefore the SmartStart features will be limited. (Flashes red, red, then orange) x 10 Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.
  • Page 33 The vehicle was detected as moving, which prevents the system from shutting it down. Flashes red x 4 Analog error codes Description Troubleshooting DEI feature error. A feature config file mismatch was detected. Please contact Technical Support. Flashes red, green & orange Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 34: Soft Reset

    A module reset will only erase the steps performed in "Module programming" on page 31. The firmware and settings flashed to the module will not be affected. Connect all but the If required for your installation, connect all the harnesses to the Directed Digital Solutions, 12-pin harness EXCEPT the 12-pin main power harness. Press and hold the programming button, then connect the 12-pin harness to the module.

  • Page 35: Learning The Tach (Not Needed With Virtual Tach)

    Important! After successfully learning Virtual Tach, a small minority of vehicle starters may over crank or under crank during remote start. Use the VirtualTach Fine tune feature in the configuration wizard to adjust the starter output time in 50mS increments to compensate for such an occurrence. Directed Digital Solutions HYUNDAI2 © 2019-05-29 Directed. All rights reserved.

  • Page 36: Limited Lifetime Consumer Warranty

    Directed dealer, the unit was professionally installed and serviced by an authorized Directed dealer; the unit will be professionally reinstalled in the vehicle in which it was originally installed by an authorized Directed dealer; and the unit is returned to Directed, shipping prepaid with a legible copy of the bill of sale or other dated proof of purchase bearing the following information: consumer’s name, telephone number and address;...

  • Page 37: Quick Reference Guide

    Factory remote. Press the Remote Start button on the transmitter.* • Aftermarket remote. • Directed SmartStart application via your smartphone. & The parking lights will flash once to indicate the Parking lights flash x1 Press Remote vehicle is now in Pit Stop Mode.
  • Page 38 SmartStart compatible This system is compatible with Directed SmartStart. For a complete list of supported features, please visit www.mysmartstart.com. What is SmartStart? Now you can remote start, lock and unlock your car just by pushing a button on your mobile device; using the SmartStart App from Directed, the leader in vehicle security and remote start.

Table of Contents