Stamina 35-1699B Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
STEP 3
Slide the SAFETY PAD(4) over the rail frame. Make sure the holes in SAFETY PAD(4) fit over the threaded
connectors properly. Refer to illustration 3.
HINT : Install one hole over a threaded connector. The next hole installed should be on the connector on
the opposite side of the trampoline.
STEP 4
Remove the Plastic Caps from the threaded connectors. Screw the LEGS(5) onto the threaded connectors
on the rail frame.
3.
B.
Second step, install the
Safety Pad(4) on the opposite
end being sure the hole fits over
the threaded connector.
STEP 5
Place the trampoline in the normal use position. Remove the LEG CAPS(7) from the two LEGS(5) as
shown in illustration 5. Slide the HANDRAIL SUPPORTS(16) onto the LEGS(5). Press the LEG CAPS(7)
back on the LEGS(5).
4.
A.
First step,
install the Safety Pad(4)
on this end being sure
the hole fits over the
threaded connector.
Remove all of the
eight Plastic Caps from the
threaded connectors before
installing the LEGS(5).
9
Threaded
Connector
5.