Stamina 35-1699B Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
STEP 1
Lay the trampoline on the floor. The trampoline will appear as shown in illustration 1.
1.
STEP 2
NOTE: Make sure the SECURE PINS(9) are inserted into the ends of RAILS(1, 2) and properly secured
by the Wire Ring. Both ends of the SECURE PINS(9) should have approximately 1/8 inch between
the RAILS(1, 2) and the Wire Ring. Refer to illustration 2.
STOP!
ALWAYS USE TWO OR MORE STRONG PEOPLE TO UNFOLD OR FOLD THE
Stamina® Intone Oval Jogger. FAILURE TO USE TWO OR MORE STRONG PEOPLE
WARNING
MAY ALLOW THE RAILS TO SPRING BACK INTO THE FOLDED POSITION AND
!
STRIKE SOMEONE WHICH CAN CAUSE SERIOUS BODILY INJURY OR DEATH.
Keep fingers away from the ends of the rails in the hinge area when unfolding the
Stamina® Intone Oval Jogger. Serious injury can occur if fingers are caught between
the ends of the RAILS.
To unfold the Stamina® Intone Oval Jogger to the flat position, hold the SEMICIRCLE RAILS(2) and push
the rails down at the same time. The SEMICIRCLE RAILS(2) and RAILS(1) should snap together and be
locked by the SECURE PINS(9) when you reach the flat position. Refer to illustration 2.
Hazard label on trampoline surface reads as follows:
! WARNING!
PREVENT serious INJURY or DEATH.
Rails can SPRING back and STRIKE someone.
ALWAYS fold and unfold carefully with TWO or
more STRONG people.
Do NOT remove this tag.
8
2.
Wire Ring