Removing The Mower Deck - Toro TimeCutter HD MyRide Operator's Manual

Figure 62
1. Deck-lift arm
2. Chain
6. Ensure that there is tension on all 4 chains
(Figure 62).
7. Tighten the 4 adjustment bolts
8. Ensure that the blocks fit snugly under the deck
skirt and that all bolts are tight.
9. Verify that the deck is level by checking the
side-to-side level and front-to-rear blade slope;
repeat the deck leveling procedure if necessary.

Removing the Mower Deck

1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
3. Lower the mower to the 76 mm (3 inches)
height-of-cut position.
4. Remove the mower belt from the engine pulley;
refer to Replacing the Mower Belt (page
5. Remove the hairpin cotter and washer securing
the link pin to the frame and deck, and remove
the link bar (Figure
3. Hook
4. Adjustment bolt
(Figure 62).
47).
63).
1. Link pin
2. Washer
6. Lift up the mower deck to relieve tension from
the mower deck.
7. Remove the chains from the hooks on the
g024313
deck-lift arms
1. Deck-lift arm
2. Chain
8. Raise the height of cut to the transport position.
9. Remove the belt from the clutch pulley on the
engine.
10. Slide the mower out from underneath the
machine.
Note:
Retain all parts for future installation.
45
Figure 63
3. Hairpin cotter
(Figure 64).
Figure 64
3. Hook
4. Adjustment bolt
g028276
g024313